P072C Mercedes Cl 500 OBD Code

OBD/2 P072C error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P072C Mercedes Cl 500 Error Code Repair Process :

If your servo motor potentiometer airintake left circuit open check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P072C and engine control unit are in charge of monitoring a bunch of different servo motor potentiometer airintake left circuit open, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mercedes Cl 500 P072C OBD2 Code

A common cause of code P072C is the failure of Servo Motor Potentiometer Airintake Left Circuit Open, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty ignition coil (s)
Incorrect fuel pressure
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

P072C is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P072C Mercedes Cl 500 OBD Code

P072C Mercedes Cl 500 Error Code Repair Process :

Common Causes of Mercedes Cl 500 P072C OBD2 Code

P072C code for other Mercedes cars