P0501 Citroen C3 Picasso OBD Code

OBD/2 P0501 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P0501 Citroen C3 Picasso Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine P0501 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If p0501 vehicle speed sensor a range/performance so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the p0501 vehicle speed sensor a range/performance.

Common Causes of Citroen C3 Picasso P0501 OBD2 Code

A common cause of code P0501 is the failure of P0501 Vehicle Speed Sensor A Range/Performance, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty front heated oxygen sensor
Erratic camshaft position due to low oil pressure
Failures of clutch motion/travel sensors.

P0501 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0501 Citroen C3 Picasso OBD Code

P0501 Citroen C3 Picasso Error Code Repair Process :

Common Causes of Citroen C3 Picasso P0501 OBD2 Code

P0501 code for other Citroen cars