P0429 Triumph 10 OBD Code

OBD/2 P0429 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC P0429 as an indication of a hard fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P0429 Triumph 10 Error Code Repair Process :

If your p0429 catalyst heater control circuit bank 1 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P0429 and engine control unit are in charge of monitoring a bunch of different p0429 catalyst heater control circuit bank 1, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Triumph 10 P0429 OBD2 Code

A common cause of code P0429 is the failure of P0429 Catalyst Heater Control Circuit Bank 1, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Continuous oil flow to the VCT piston chamber
Faulty select solenoid
Erratic camshaft position due to low oil pressure

P0429 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0429 Triumph 10 OBD Code

P0429 Triumph 10 Error Code Repair Process :

Common Causes of Triumph 10 P0429 OBD2 Code

P0429 code for other Triumph cars