Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.
Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P02EE, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P02EE on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.
When you turn on the ignition, the Service Engine Soon or Check Engine P02EE light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If pcm processor fault so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the pcm processor fault.
Difficulty Level (Soso)
![]() |
Repair Time (50 Min.)
![]() |
Cost Prediction : $ 30-110 |
![]() |
P02EE is a kind of Powertrain Trouble Code
Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air. |
You can view according P02EE DTC for your car model. We selected several models to see obd2 solutions click and view it.