P0262 Nissan Be-1 OBD Code

OBD/2 P0262 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P0262 Nissan Be-1 Error Code Repair Process :

If your p0262 cylinder 1 injector circuit high check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P0262 and engine control unit are in charge of monitoring a bunch of different p0262 cylinder 1 injector circuit high, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Nissan Be-1 P0262 OBD2 Code

A common cause of code P0262 is the failure of P0262 Cylinder 1 Injector Circuit High, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Damaged camshaft position (CMP) sensor
Fuel pressure
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted

P0262 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0262 Nissan Be-1 OBD Code

P0262 Nissan Be-1 Error Code Repair Process :

Common Causes of Nissan Be-1 P0262 OBD2 Code

P0262 code for other Nissan cars