P007E Panhard 24 OBD Code

OBD/2 P007E error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P007E Panhard 24 Error Code Repair Process :

If your vehicle failed a P007E test and the P007E Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses scp (j1850) invalid or missing data for interior lamps a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look scp (j1850) invalid or missing data for interior lamps: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Easy)

Repair Time (20 Min.)

Cost Prediction : $ 20-50

Common Causes of Panhard 24 P007E OBD2 Code

A common cause of code P007E is the failure of SCP (J1850) Invalid or Missing Data for Interior Lamps, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Faulty oil control valve (OCV)
• Incorrect Positive Crankcase Ventilation (PCV) hose connection
• Intake air leaks

P007E is a kind of Powertrain Trouble Code Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P007E code for other Panhard cars

You can view according P007E DTC for your car model. We selected several models to see obd2 solutions click and view it.

• P007E Panhard 120
• P007E Panhard Cd
• P007E Panhard Dyna
• P007E Panhard Et Levassor 50
• P007E Panhard Et Levassor B1
• P007E Panhard Et Levassor Gordon-bennet
• P007E Panhard Et Levassor Panhard Et Levassor
• P007E Panhard Et Levassor X
• P007E Panhard Junior
• P007E Panhard L5
• P007E Panhard L6
• P007E Panhard Pl

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved