C3816 Bristol 403 OBD Code

OBD/2 C3816 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C3816 Bristol 403 Error Code Repair Process :

If your accelerometer rear circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C3816 and engine control unit are in charge of monitoring a bunch of different accelerometer rear circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Difficulty Level (Soso)

Repair Time (30 Min.)

Cost Prediction : $ 80-120

Common Causes of Bristol 403 C3816 OBD2 Code

A common cause of code C3816 is the failure of Accelerometer Rear Circuit Short To Ground, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Incorrect Positive Crankcase Ventilation (PCV) hose connection
• Fuel injector leaks

C3816 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C3816 code for other Bristol cars

You can view according C3816 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C3816 Briscoe Cloverleaf
• C3816 Bristol 400
• C3816 Bristol 401
• C3816 Bristol 402
• C3816 Bristol 404
• C3816 Bristol 405
• C3816 Bristol 406
• C3816 Bristol 407
• C3816 Bristol 408
• C3816 Bristol 409
• C3816 Bristol 410
• C3816 Bristol 411
• C3816 Bristol 412
• C3816 Bristol 450
• C3816 Bristol 603
• C3816 Bristol Beaufighter
• C3816 Bristol Blenheim
• C3816 Bristol Brigand
• C3816 Bristol Britannia
• C3816 Bristol Fighter

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved