C3735 Mercury Mountaineer Iii OBD Code

OBD/2 C3735 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

C3735 Mercury Mountaineer Iii Error Code Repair Process :

The rule of C3735 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of abs outlet valve coil lr circuit open. Likewise, overriding the OBD C3735 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mercury Mountaineer Iii C3735 OBD2 Code

A common cause of code C3735 is the failure of ABS Outlet Valve Coil LR Circuit Open, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Ignition coils circuit poor electrical connection
Damaged VCT phaser

C3735 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C3735 Mercury Mountaineer Iii OBD Code

C3735 Mercury Mountaineer Iii Error Code Repair Process :

Common Causes of Mercury Mountaineer Iii C3735 OBD2 Code

C3735 code for other Mercury cars