Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
The rule of C3641 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of wheel speed sensor rf tone ring tooth missing fault. Likewise, overriding the OBD C3641 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
Difficulty Level (Easy)
|
Repair Time (20 Min.)
|
Cost Prediction : $ 60-110 |
C3641 is a kind of Chassis Trouble Code
Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise. |
You can view according C3641 DTC for your car model. We selected several models to see obd2 solutions click and view it.