C3252 Morris 1800 OBD Code

OBD/2 C3252 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C3252 Morris 1800 Error Code Repair Process :

If your rear washer input short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C3252 and engine control unit are in charge of monitoring a bunch of different rear washer input short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Morris 1800 C3252 OBD2 Code

A common cause of code C3252 is the failure of Rear Washer Input Short to Ground, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
EVAP canister or fuel tank leaks
Fuel Injectors circuit poor electrical connection
Open or short in the VCT circuit

C3252 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C3252 Morris 1800 OBD Code

C3252 Morris 1800 Error Code Repair Process :

Common Causes of Morris 1800 C3252 OBD2 Code

C3252 code for other Morris cars