C3252 Lanchester 40 OBD Code

OBD/2 C3252 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

C3252 Lanchester 40 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C3252 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If rear washer input short to ground so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the rear washer input short to ground.

Common Causes of Lanchester 40 C3252 OBD2 Code

A common cause of code C3252 is the failure of Rear Washer Input Short to Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Dirty Oil
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Internal electrical failures in actuator motors/solenoids.

C3252 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C3252 Lanchester 40 OBD Code

C3252 Lanchester 40 Error Code Repair Process :

Common Causes of Lanchester 40 C3252 OBD2 Code

C3252 code for other Lanchester cars