C3198 Plymouth Acclaim OBD Code

OBD/2 C3198 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C3198, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C3198 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C3198 Plymouth Acclaim Error Code Repair Process :

The rule of C3198 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of seat rear up/down potentiometer feedback circuit short to ground. Likewise, overriding the OBD C3198 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Plymouth Acclaim C3198 OBD2 Code

A common cause of code C3198 is the failure of Seat Rear Up/Down Potentiometer Feedback Circuit Short To Ground, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Dirty Oil
Incorrect fuel filler cap used
Variable Camshaft Timing (VCT) position circuit poor electrical connection

C3198 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C3198 Plymouth Acclaim OBD Code

C3198 Plymouth Acclaim Error Code Repair Process :

Common Causes of Plymouth Acclaim C3198 OBD2 Code

C3198 code for other Plymouth cars