C3132 Saab 9-7x OBD Code

OBD/2 C3132 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

C3132 Saab 9-7x Error Code Repair Process :

The scent may C3132 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C3132, so if the inside of your car pad warning lamp inoperative as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 90-120

Common Causes of Saab 9-7x C3132 OBD2 Code

A common cause of code C3132 is the failure of PAD Warning Lamp Inoperative, but there are several other possible causes as well, such as ;

• EVAP canister or fuel tank leaks
• Clogged or faulty fuel injector (s)
• Dirty Oil
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

C3132 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C3132 code for other Saab cars

You can view according C3132 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C3132 Saab 750
• C3132 Saab 9.3
• C3132 Saab 9.3 Ii
• C3132 Saab 9.5
• C3132 Saab 9.5 Ii
• C3132 Saab 90
• C3132 Saab 900
• C3132 Saab 9000
• C3132 Saab 9000i
• C3132 Saab 900i
• C3132 Saab 92
• C3132 Saab 9-2
• C3132 Saab 9-2x
• C3132 Saab 93
• C3132 Saab 9-3
• C3132 Saab 95
• C3132 Saab 9-5
• C3132 Saab 96
• C3132 Saab 9-7
• C3132 Saab 99
• C3132 Saab 9-x
• C3132 Saab Aero-x
• C3132 Saab Gt
• C3132 Saab Mc
• C3132 Saab Sonett

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved