C3117 Trouble Code

View C3117 obd/2 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

Difficulty Level (Soso)

Repair Time (50 Min.)

Cost Prediction : $ 20-50

C3117 Error Code Repair Process :

If your vehicle failed a C3117 test and the C3117 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses lamp air bag warning indicator circuit open a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look lamp air bag warning indicator circuit open: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

C3117 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Common Causes of C3117

A common cause of code C3117 is the failure of Lamp Air Bag Warning Indicator Circuit Open, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Dirty Oil
• Ignition coils circuit poor electrical connection
• 1Camshaft Position Sensor circuit poor electrical connection

C3117 code for all cars

You can view according C3117 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+C3117 Studebaker Sky Hawk

+C3117 Fioravanti Sensiva

+C3117 Toyota Aristo

+C3117 Gmc Safari

+C3117 Hyundai Atoz

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved