C2A08 Dkw F12 OBD Code

OBD/2 C2A08 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

C2A08 Dkw F12 Error Code Repair Process :

The rule of C2A08 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of mirror driver horizontal switch circuit short to ground. Likewise, overriding the OBD C2A08 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Dkw F12 C2A08 OBD2 Code

A common cause of code C2A08 is the failure of Mirror Driver Horizontal Switch Circuit Short To Ground, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Exhaust tube
Continuous oil flow to the VCT piston chamber
Faulty Fuel injector

C2A08 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2A08 Dkw F12 OBD Code

C2A08 Dkw F12 Error Code Repair Process :

Common Causes of Dkw F12 C2A08 OBD2 Code

C2A08 code for other Dkw cars