C2884 Ford Ikon OBD Code

OBD/2 C2884 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

As long as the throttle plate remains closed, the idling speed and quality is controlled by the PCM via the idle control valve, and as can be seen from the above it should be clear that idle control on a gasoline engine is a complex affair. For instance, if the engine is started in sub-zero temperatures, the PCM will command the idling control valve to allow less air to enter the engine to enrich the air/fuel mixture to create a condition which is roughly analogous to how chokes worked on carburetted engines to control idling in cold weather.

C2884 Ford Ikon Error Code Repair Process :

The scent may C2884 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C2884, so if the inside of your car wiper rear mode select switch circuit short to ground as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Ford Ikon C2884 OBD2 Code

A common cause of code C2884 is the failure of Wiper Rear Mode Select Switch Circuit Short To Ground, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Continuous oil flow to the VCT piston chamber
Faulty Camshaft Position Sensor

C2884 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2884 Ford Ikon OBD Code

C2884 Ford Ikon Error Code Repair Process :

Common Causes of Ford Ikon C2884 OBD2 Code

C2884 code for other Ford cars