C281D Lotus 2-eleven OBD Code

OBD/2 C281D error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C281D Lotus 2-eleven Error Code Repair Process :

The rule of C281D code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of memory set switch circuit open. Likewise, overriding the OBD C281D error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Lotus 2-eleven C281D OBD2 Code

A common cause of code C281D is the failure of Memory Set Switch Circuit Open, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Camshaft advance mechanism binding (VCT unit)
Incorrect fuel filler cap used
Loss of ground.

C281D is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C281D Lotus 2-eleven OBD Code

C281D Lotus 2-eleven Error Code Repair Process :

Common Causes of Lotus 2-eleven C281D OBD2 Code

C281D code for other Lotus cars