C2808 Mitsubishi Rpm OBD Code

OBD/2 C2808 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2808 Mitsubishi Rpm Error Code Repair Process :

The scent may C2808 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C2808, so if the inside of your car driver door handle circuit open as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Mitsubishi Rpm C2808 OBD2 Code

A common cause of code C2808 is the failure of Driver Door Handle Circuit Open, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Exhaust tube
Open circuits caused by corrosion of electrical connectors.

C2808 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2808 Mitsubishi Rpm OBD Code

C2808 Mitsubishi Rpm Error Code Repair Process :

Common Causes of Mitsubishi Rpm C2808 OBD2 Code

C2808 code for other Mitsubishi cars