C2808 Metallurgique 12 OBD Code

OBD/2 C2808 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC C2808 as an indication of a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C2808, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C2808 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C2808 Metallurgique 12 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2808 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If driver door handle circuit open so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the driver door handle circuit open.

Difficulty Level (Soso)

Repair Time (50 Min.)

Cost Prediction : $ 30-110

Common Causes of Metallurgique 12 C2808 OBD2 Code

A common cause of code C2808 is the failure of Driver Door Handle Circuit Open, but there are several other possible causes as well, such as ;

• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Exhaust tube
• Fuel injectors may be faulty
• Insufficient cylinders compression

C2808 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C2808 code for other Metallurgique cars

You can view according C2808 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C2808 Metallurgique 26

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved