C2695 Chrysler Airflite OBD Code

OBD/2 C2695 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC C2695 as an indication of a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C2695, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C2695 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C2695 Chrysler Airflite Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2695 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If oil change lamp circuit short to ground so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the oil change lamp circuit short to ground.

Common Causes of Chrysler Airflite C2695 OBD2 Code

A common cause of code C2695 is the failure of Oil Change Lamp Circuit Short To Ground, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Damaged camshaft position (CMP) sensor
Engine Control Module (ECM)
Engine Control Module (ECM)

C2695 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2695 Chrysler Airflite OBD Code

C2695 Chrysler Airflite Error Code Repair Process :

Common Causes of Chrysler Airflite C2695 OBD2 Code

C2695 code for other Chrysler cars