C2614 Peugeot 907 OBD Code

OBD/2 C2614 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C2614, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C2614 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C2614 Peugeot 907 Error Code Repair Process :

For servo motor potentiometer vent circuit failure check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C2614 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks servo motor potentiometer vent circuit failure with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Peugeot 907 C2614 OBD2 Code

A common cause of code C2614 is the failure of Servo Motor Potentiometer Vent Circuit Failure, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty TCM or TCM programming
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Damaged camshaft position (CMP) sensor

C2614 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2614 Peugeot 907 OBD Code

C2614 Peugeot 907 Error Code Repair Process :

Common Causes of Peugeot 907 C2614 OBD2 Code

C2614 code for other Peugeot cars