C2614 Land Rover Freelander 2 OBD Code

OBD/2 C2614 error code description and symptoms.

Variable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position. Cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) C2614 DTC is a check of the VCT unit.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2614 Land Rover Freelander 2 Error Code Repair Process :

If your servo motor potentiometer vent circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2614 and engine control unit are in charge of monitoring a bunch of different servo motor potentiometer vent circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Difficulty Level (Soso)

Repair Time (30 Min.)

Cost Prediction : $ 80-120

Common Causes of Land Rover Freelander 2 C2614 OBD2 Code

A common cause of code C2614 is the failure of Servo Motor Potentiometer Vent Circuit Failure, but there are several other possible causes as well, such as ;

• Camshaft advance mechanism binding (VCT unit)
• Faulty ignition coil (s)
• Incorrect fuel filler cap used
• Faulty front heated oxygen sensor

C2614 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C2614 code for other Land cars

You can view according C2614 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C2614 Land Rover Defender
• C2614 Land Rover Discovery
• C2614 Land Rover Discovery 2
• C2614 Land Rover Discovery 3
• C2614 Land Rover Discovery 4
• C2614 Land Rover Discovery 5
• C2614 Land Rover Evoque
• C2614 Land Rover Freelander
• C2614 Land Rover Lr2
• C2614 Land Rover Lr3
• C2614 Land Rover Range Rover
• C2614 Land Rover Serie I
• C2614 Land Rover Series I
• C2614 Land Rover Series Ii
• C2614 Land Rover Series Iii
• C2614 Land Rover Velar

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved