C2594 Peugeot 301 OBD Code

OBD/2 C2594 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C2594 Peugeot 301 Error Code Repair Process :

The rule of C2594 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of dim panel potentiometer switch circuit failure. Likewise, overriding the OBD C2594 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Peugeot 301 C2594 OBD2 Code

A common cause of code C2594 is the failure of Dim Panel Potentiometer Switch Circuit Failure, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty variable valve timing (VVT)
Faulty variable valve timing (VVT)

C2594 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2594 Peugeot 301 OBD Code

C2594 Peugeot 301 Error Code Repair Process :

Common Causes of Peugeot 301 C2594 OBD2 Code

C2594 code for other Peugeot cars