C2535 Mitsubishi Diamante OBD Code

OBD/2 C2535 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2535 Mitsubishi Diamante Error Code Repair Process :

The rule of C2535 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of transmission transfer case differential lock-up feedback switch circuit failure. Likewise, overriding the OBD C2535 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mitsubishi Diamante C2535 OBD2 Code

A common cause of code C2535 is the failure of Transmission Transfer Case Differential Lock-Up Feedback Switch Circuit Failure, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty front heated oxygen sensor
Camshaft advance mechanism binding (VCT unit)

C2535 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2535 Mitsubishi Diamante OBD Code

C2535 Mitsubishi Diamante Error Code Repair Process :

Common Causes of Mitsubishi Diamante C2535 OBD2 Code

C2535 code for other Mitsubishi cars