C2419 Peugeot 405 OBD Code

OBD/2 C2419 error code description and symptoms.

Brake Switch Circuit Input Malfunction Indicates PCM did not receive a brake pedal position (BPP) input. Open or short in BPP circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit. (Rear Electronic Module [REM] Windstar and LS6/LS8 or Lighting Control Module (LCM) Continental and Town Car. Damaged brake switch Misadjusted brake switch Check for proper function of stoplamps.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2419 Peugeot 405 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2419 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If fuel pump resistor switch circuit malfunction so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the fuel pump resistor switch circuit malfunction.

Common Causes of Peugeot 405 C2419 OBD2 Code

A common cause of code C2419 is the failure of Fuel Pump Resistor Switch Circuit Malfunction, but there are several other possible causes as well, such as ;

Failures of clutch motion/travel sensors.
Faulty ignition coil (s)
Incorrect Positive Crankcase Ventilation (PCV) hose connection
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

C2419 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2419 Peugeot 405 OBD Code

C2419 Peugeot 405 Error Code Repair Process :

Common Causes of Peugeot 405 C2419 OBD2 Code

C2419 code for other Peugeot cars