C2413 Honda Fit OBD Code

OBD/2 C2413 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2413 Honda Fit Error Code Repair Process :

If your vehicle id block corrupted or not programmed check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2413 and engine control unit are in charge of monitoring a bunch of different vehicle id block corrupted or not programmed, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Honda Fit C2413 OBD2 Code

A common cause of code C2413 is the failure of Vehicle ID Block Corrupted or Not Programmed, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty spark plug (s)

C2413 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2413 Honda Fit OBD Code

C2413 Honda Fit Error Code Repair Process :

Common Causes of Honda Fit C2413 OBD2 Code

C2413 code for other Honda cars