C2413 Ferrari 288 OBD Code

OBD/2 C2413 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C2413 Ferrari 288 Error Code Repair Process :

The rule of C2413 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of vehicle id block corrupted or not programmed. Likewise, overriding the OBD C2413 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Ferrari 288 C2413 OBD2 Code

A common cause of code C2413 is the failure of Vehicle ID Block Corrupted or Not Programmed, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Engine Control Module (ECM)
Incorrect fuel pressure
1Camshaft Position Sensor circuit poor electrical connection

C2413 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2413 Ferrari 288 OBD Code

C2413 Ferrari 288 Error Code Repair Process :

Common Causes of Ferrari 288 C2413 OBD2 Code

C2413 code for other Ferrari cars