C228C Alvis Ta21 OBD Code

OBD/2 C228C error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

C228C Alvis Ta21 Error Code Repair Process :

The scent may C228C signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C228C, so if the inside of your car a/c compressor temperature sensor malfunction as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Alvis Ta21 C228C OBD2 Code

A common cause of code C228C is the failure of A/C Compressor Temperature Sensor Malfunction, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty TCM or TCM programming
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Oil flow restriction in the oil passages or the variable camshaft timing (VCT) valve body

C228C is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C228C Alvis Ta21 OBD Code

C228C Alvis Ta21 Error Code Repair Process :

Common Causes of Alvis Ta21 C228C OBD2 Code

C228C code for other Alvis cars