C2219 Nissan Pathfinder OBD Code

OBD/2 C2219 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2219 Nissan Pathfinder Error Code Repair Process :

If your variable cam timing overadvanced (bank #1)/ misfire detected - no communication with bcm check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2219 and engine control unit are in charge of monitoring a bunch of different variable cam timing overadvanced (bank #1)/ misfire detected - no communication with bcm, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Nissan Pathfinder C2219 OBD2 Code

A common cause of code C2219 is the failure of Variable Cam Timing Overadvanced (Bank #1)/ Misfire Detected - No Communication with BCM, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Faulty select solenoid
Faulty TCM or TCM programming
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

C2219 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2219 Nissan Pathfinder OBD Code

C2219 Nissan Pathfinder Error Code Repair Process :

Common Causes of Nissan Pathfinder C2219 OBD2 Code

C2219 code for other Nissan cars