C2147 Volvo V90 OBD Code

OBD/2 C2147 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C2147 Volvo V90 Error Code Repair Process :

If your pedal correlation pds1 and pds2 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2147 and engine control unit are in charge of monitoring a bunch of different pedal correlation pds1 and pds2, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Volvo V90 C2147 OBD2 Code

A common cause of code C2147 is the failure of Pedal Correlation PDS1 and PDS2, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Damaged ECM
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Clogged or faulty fuel injector (s)

C2147 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C2147 Volvo V90 OBD Code

C2147 Volvo V90 Error Code Repair Process :

Common Causes of Volvo V90 C2147 OBD2 Code

C2147 code for other Volvo cars