C2134 Holden Gts OBD Code

OBD/2 C2134 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2134 Holden Gts Error Code Repair Process :

If your sensor power supply malfunction check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2134 and engine control unit are in charge of monitoring a bunch of different sensor power supply malfunction, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Holden Gts C2134 OBD2 Code

A common cause of code C2134 is the failure of Sensor Power Supply Malfunction, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Improper ignition timing
Spark plugs may be faulty

C2134 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2134 Holden Gts OBD Code

C2134 Holden Gts Error Code Repair Process :

Common Causes of Holden Gts C2134 OBD2 Code

C2134 code for other Holden cars