C1964 Peugeot 404 OBD Code

OBD/2 C1964 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C1964 Peugeot 404 Error Code Repair Process :

If your vehicle failed a C1964 test and the C1964 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses exhaust pressure sensor malfunction a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look exhaust pressure sensor malfunction: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Peugeot 404 C1964 OBD2 Code

A common cause of code C1964 is the failure of Exhaust Pressure Sensor Malfunction, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Continuous oil flow to the VCT piston chamber
Faulty Mass Air Flow (MAF) sensor
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

C1964 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1964 Peugeot 404 OBD Code

C1964 Peugeot 404 Error Code Repair Process :

Common Causes of Peugeot 404 C1964 OBD2 Code

C1964 code for other Peugeot cars