C1900 Mazda 787 OBD Code

OBD/2 C1900 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

C1900 Mazda 787 Error Code Repair Process :

The rule of C1900 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of c1900 steering vaps ii circuit loop short to ground. Likewise, overriding the OBD C1900 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mazda 787 C1900 OBD2 Code

A common cause of code C1900 is the failure of C1900 Steering VAPS II Circuit Loop Short To Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty ignition coil (s)
Ignition coils circuit poor electrical connection
Three way catalyst converter Bank 1

C1900 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1900 Mazda 787 OBD Code

C1900 Mazda 787 Error Code Repair Process :

Common Causes of Mazda 787 C1900 OBD2 Code

C1900 code for other Mazda cars