C1728 Hyundai Solaris OBD Code

OBD/2 C1728 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C1728 Hyundai Solaris Error Code Repair Process :

If your c1728 transfer case unable to transition between 2h and 4h check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1728 and engine control unit are in charge of monitoring a bunch of different c1728 transfer case unable to transition between 2h and 4h, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Hyundai Solaris C1728 OBD2 Code

A common cause of code C1728 is the failure of C1728 Transfer Case unable to transition between 2H and 4H, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Faulty select solenoid
EVAP canister or fuel tank leaks
Internal electrical failures in actuator motors/solenoids.

C1728 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1728 Hyundai Solaris OBD Code

C1728 Hyundai Solaris Error Code Repair Process :

Common Causes of Hyundai Solaris C1728 OBD2 Code

C1728 code for other Hyundai cars