C1701 Austin 16 OBD Code

OBD/2 C1701 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

C1701 Austin 16 Error Code Repair Process :

For c1701 left rear sensor circuit fault check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C1701 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks c1701 left rear sensor circuit fault with your car's computers to find out exactly what's prompting the light to turn on.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 70-120

Common Causes of Austin 16 C1701 OBD2 Code

A common cause of code C1701 is the failure of C1701 Left Rear Sensor Circuit Fault, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Failures of clutch motion/travel sensors.
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Loss of ground.

C1701 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C1701 code for other Austin cars

You can view according C1701 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C1701 Austin 10
• C1701 Austin 12
• C1701 Austin 1300
• C1701 Austin 14
• C1701 Austin 18
• C1701 Austin 1800
• C1701 Austin 20
• C1701 Austin 2200
• C1701 Austin 28
• C1701 Austin 3
• C1701 Austin 3-litre
• C1701 Austin 7
• C1701 Austin 8
• C1701 Austin A110
• C1701 Austin A125
• C1701 Austin A135
• C1701 Austin A30
• C1701 Austin A35
• C1701 Austin A40
• C1701 Austin A55
• C1701 Austin A60
• C1701 Austin A70
• C1701 Austin A90
• C1701 Austin A95
• C1701 Austin A99
• C1701 Austin Allegro
• C1701 Austin Ambassador
• C1701 Austin Maestro
• C1701 Austin Marina
• C1701 Austin Maxi
• C1701 Austin Metro
• C1701 Austin Mini
• C1701 Austin Montego
• C1701 Austin Princess
• C1701 Austin Seven
• C1701 Austin Sports
• C1701 Austin-healey 100
• C1701 Austin-healey 3000
• C1701 Austin-healey Sport
• C1701 Austin-healey Sports
• C1701 Austin-healey Sprite
• C1701 Austin-healey Tickford
• C1701 Austro-daimler 27
• C1701 Austro-daimler Ad
• C1701 Austro-daimler Adm
• C1701 Austro-daimler Adr

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved