C156E Fiat 131 OBD Code

OBD/2 C156E error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC C156E as an indication of a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C156E, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C156E on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C156E Fiat 131 Error Code Repair Process :

The rule of C156E code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of . Likewise, overriding the OBD C156E error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Fiat 131 C156E OBD2 Code

A common cause of code C156E is the failure of , but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Faulty oil control valve (OCV)
Exhaust gas leaks

C156E is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C156E Fiat 131 OBD Code

C156E Fiat 131 Error Code Repair Process :

Common Causes of Fiat 131 C156E OBD2 Code

C156E code for other Fiat cars