C1453 Simca Vedette Versailles OBD Code

OBD/2 C1453 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C1453 Simca Vedette Versailles Error Code Repair Process :

The rule of C1453 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of c1453 traction control motor circuit short to ground. Likewise, overriding the OBD C1453 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Simca Vedette Versailles C1453 OBD2 Code

A common cause of code C1453 is the failure of C1453 Traction Control Motor Circuit Short to Ground, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Engine Control Module (ECM)
Faulty select solenoid
Engine Control Module (ECM)

C1453 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1453 Simca Vedette Versailles OBD Code

C1453 Simca Vedette Versailles Error Code Repair Process :

Common Causes of Simca Vedette Versailles C1453 OBD2 Code

C1453 code for other Simca cars