C12DF Packard Custom OBD Code

OBD/2 C12DF error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C12DF Packard Custom Error Code Repair Process :

If your vehicle failed a C12DF test and the C12DF Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 20-50

Common Causes of Packard Custom C12DF OBD2 Code

A common cause of code C12DF is the failure of , but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Engine Control Module (ECM)
• Fuel tank leaking
• Faulty Crankshaft Position Sensor (POS)

C12DF is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C12DF code for other Packard cars

You can view according C12DF DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C12DF Packard 12
• C12DF Packard 120
• C12DF Packard 200
• C12DF Packard 300
• C12DF Packard 400
• C12DF Packard 7
• C12DF Packard A
• C12DF Packard Carribean
• C12DF Packard Cavalier
• C12DF Packard Clipper
• C12DF Packard De
• C12DF Packard Eight
• C12DF Packard Executive
• C12DF Packard Mayfair
• C12DF Packard Patrician
• C12DF Packard Super
• C12DF Packard Twelve
• C12DF Packard Twin

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved