C1182 Peugeot Rifter OBD Code

OBD/2 C1182 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C1182 Peugeot Rifter Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C1182 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If c1182 park lamp flash relay circuit failure so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the c1182 park lamp flash relay circuit failure.

Common Causes of Peugeot Rifter C1182 OBD2 Code

A common cause of code C1182 is the failure of C1182 Park Lamp Flash Relay Circuit Failure, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Camshaft Position Sensor
Faulty Crankshaft Position Sensor (POS)
Oil Control Valve (OCV) circuit is open or shorted

C1182 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1182 Peugeot Rifter OBD Code

C1182 Peugeot Rifter Error Code Repair Process :

Common Causes of Peugeot Rifter C1182 OBD2 Code

C1182 code for other Peugeot cars