C1114 Subaru Vivio OBD Code

OBD/2 C1114 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

C1114 Subaru Vivio Error Code Repair Process :

If your c1114 abs power relay output short circuit to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1114 and engine control unit are in charge of monitoring a bunch of different c1114 abs power relay output short circuit to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Subaru Vivio C1114 OBD2 Code

A common cause of code C1114 is the failure of C1114 ABS Power Relay Output Short Circuit To Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Mass Air Flow (MAF) sensor
Fuel injectors may be faulty
Incorrect Positive Crankcase Ventilation (PCV) hose connection

C1114 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1114 Subaru Vivio OBD Code

C1114 Subaru Vivio Error Code Repair Process :

Common Causes of Subaru Vivio C1114 OBD2 Code

C1114 code for other Subaru cars