C1002 Lanchester 18 OBD Code

OBD/2 C1002 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C1002, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C1002 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C1002 Lanchester 18 Error Code Repair Process :

If your abs inlet valve coil rr circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1002 and engine control unit are in charge of monitoring a bunch of different abs inlet valve coil rr circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Lanchester 18 C1002 OBD2 Code

A common cause of code C1002 is the failure of ABS Inlet Valve Coil RR Circuit Short To Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Ignition coils harness is open or shorted
Faulty variable valve timing (VVT)

C1002 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1002 Lanchester 18 OBD Code

C1002 Lanchester 18 Error Code Repair Process :

Common Causes of Lanchester 18 C1002 OBD2 Code

C1002 code for other Lanchester cars