C0885 Talbot 1510 OBD Code

OBD/2 C0885 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

C0885 Talbot 1510 Error Code Repair Process :

The rule of C0885 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of clutch position ckt short to battery. Likewise, overriding the OBD C0885 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Talbot 1510 C0885 OBD2 Code

A common cause of code C0885 is the failure of Clutch position ckt short to battery, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Clogged or faulty fuel injector (s)
Camshaft advance mechanism binding (VCT unit)
EVAP canister or fuel tank leaks

C0885 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C0885 Talbot 1510 OBD Code

C0885 Talbot 1510 Error Code Repair Process :

Common Causes of Talbot 1510 C0885 OBD2 Code

C0885 code for other Talbot cars