C0766 Nissan Juke OBD Code

OBD/2 C0766 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C0766, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C0766 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C0766 Nissan Juke Error Code Repair Process :

The rule of C0766 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of anti theft horn output circuit failure. Likewise, overriding the OBD C0766 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Nissan Juke C0766 OBD2 Code

A common cause of code C0766 is the failure of ANTI THEFT HORN OUTPUT CIRCUIT Failure, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty front heated oxygen sensor
Faulty front heated oxygen sensor
Improper ignition timing

C0766 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C0766 Nissan Juke OBD Code

C0766 Nissan Juke Error Code Repair Process :

Common Causes of Nissan Juke C0766 OBD2 Code

C0766 code for other Nissan cars