C0720 Sunbeam 20 OBD Code

OBD/2 C0720 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C0720 Sunbeam 20 Error Code Repair Process :

OBD C0720 code and tailpipe testing are two different approaches to identify vehicles in need of repair. The OBD system looks for broken or malfunctioning emissions control components and rescu/vems input circuit short to battery, while tailpipe tests sample a vehicle's exhaust to see if it is above or below certain prescribed limits. Given the robust nature of today's emissions control components, it is entirely possible for an individual component to C0720 malfunction without leading to an immediate increase in emissions at the tailpipe. In such cases, other components (like the catalyst) can temporarily compensate for the part that is broken however, these other components can only do double duty for so long before they, too, begin to malfunction. In addition, OBD also monitors for C0720 and other malfunctions in the fuel system problems that traditional tailpipe tests were not designed to identify. Most state and local areas also include a gas cap pressure test as part of an emission inspection.

Common Causes of Sunbeam 20 C0720 OBD2 Code

A common cause of code C0720 is the failure of RESCU/VEMS Input Circuit Short to Battery, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Intake Valve Timing Control Solenoid Valve
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

C0720 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C0720 Sunbeam 20 OBD Code

C0720 Sunbeam 20 Error Code Repair Process :

Common Causes of Sunbeam 20 C0720 OBD2 Code

C0720 code for other Sunbeam cars