C0548 Trouble Code

View C0548 obd/2 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

Difficulty Level (Easy)

Repair Time (20 Min.)

Cost Prediction : $ 60-110

C0548 Error Code Repair Process :

The rule of C0548 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of gear shift position fault. Likewise, overriding the OBD C0548 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

C0548 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Common Causes of C0548

A common cause of code C0548 is the failure of Gear shift position Fault, but there are several other possible causes as well, such as ;

• Exhaust tube
• Exhaust gas leaks
• Faulty select solenoid
• Damaged camshaft position (CMP) sensor

C0548 code for all cars

You can view according C0548 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+C0548 Rover 2600

+C0548 Graham 26

+C0548 Acura Loctite

+C0548 Mitsubishi Outlander

+C0548 Eagle Summit

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved