C0381 Peugeot Tulip OBD Code

OBD/2 C0381 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C0381 Peugeot Tulip Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C0381 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If turn signal / hazard switch signal circuit failure so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the turn signal / hazard switch signal circuit failure.

Common Causes of Peugeot Tulip C0381 OBD2 Code

A common cause of code C0381 is the failure of Turn Signal / Hazard Switch Signal Circuit Failure, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Engine Control Module (ECM)
Faulty Camshaft Position Sensor
Insufficient cylinders compression

C0381 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C0381 Peugeot Tulip OBD Code

C0381 Peugeot Tulip Error Code Repair Process :

Common Causes of Peugeot Tulip C0381 OBD2 Code

C0381 code for other Peugeot cars