C0162 Bmw 520i OBD Code

OBD/2 C0162 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

C0162 Bmw 520i Error Code Repair Process :

If your seat driver recline backward circuit short to battery check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C0162 and engine control unit are in charge of monitoring a bunch of different seat driver recline backward circuit short to battery, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Bmw 520i C0162 OBD2 Code

A common cause of code C0162 is the failure of Seat Driver Recline Backward Circuit Short To Battery, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Damaged ECM
Ignition coils circuit poor electrical connection
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

C0162 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C0162 Bmw 520i OBD Code

C0162 Bmw 520i Error Code Repair Process :

Common Causes of Bmw 520i C0162 OBD2 Code

C0162 code for other Bmw cars