B3993 Sunbeam 10 OBD Code

OBD/2 B3993 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC B3993 as an indication of a hard fault.

Circuit High Input codes like B3993 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

B3993 Sunbeam 10 Error Code Repair Process :

If your wiper washer fluid lamp circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system B3993 and engine control unit are in charge of monitoring a bunch of different wiper washer fluid lamp circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Sunbeam 10 B3993 OBD2 Code

A common cause of code B3993 is the failure of Wiper Washer Fluid Lamp Circuit Short To Ground, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
1Camshaft Position Sensor circuit poor electrical connection
Camshaft advance mechanism binding (VCT unit)
Fuel injector leaks

B3993 Sunbeam 10 OBD Code

B3993 Sunbeam 10 Error Code Repair Process :

Common Causes of Sunbeam 10 B3993 OBD2 Code

B3993 code for other Sunbeam cars