B3974 Trouble Code

View B3974 obd/2 error code description and symptoms. B3974 engine photo

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

Difficulty Level (Expert)
Level
Repair Time (35 Min.)
Time
Cost Prediction : $ 60-110

B3974 Error Code Repair Process :

The rule of B3974 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of wiper mode select switch circuit failure. Likewise, overriding the OBD B3974 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Wrench Tool B3974 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Common Causes of B3974

A common cause of code B3974 is the failure of Wiper Mode Select Switch Circuit Failure, but there are several other possible causes as well, such as ;

B3974 code for all cars

You can view according B3974 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+B3974 Salmson S.4.61 +B3974 Toyota Corsa +B3974 Buick Lacrosse +B3974 Opel Corsa D +B3974 Mercedes C 180

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved