Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.
Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code B3781, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code B3781 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.
If your wiper rear motor run relay circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system B3781 and engine control unit are in charge of monitoring a bunch of different wiper rear motor run relay circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.
Difficulty Level (Soso)
|
Repair Time (50 Min.)
|
| Cost Prediction : $ 40-75 |
|
B3781 is a kind of Body Trouble Code
Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems. |
You can view according B3781 DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved